patricia, what you are describing is known as Pneumatic retinopexy. It is a newer method for repairing retinal detachments. It usually is performed on an outpatient basis under local anesthesia. Laser or cryotherapy is used to seal the hole or tear. The surgeon then injects a gas bubble directly inside the vitreous cavity of the eye to push the detached retina against the back outer wall of the eye (sclera). The gas bubble initially expands and then disappears over two to six weeks. Proper positioning of the head in the postoperative time period is crucial for success. Although this treatment is inappropriate for the repair of many retinal detachments, it is simpler and much less costly than scleral buckling. Furthermore, if pneumatic retinopexy is unsuccessful, scleral buckling still can be performed.

For many years, scleral buckling has been the standard treatment for detached retinas. The surgery is done in a hospital operating room with general or local anesthesia. Some patients stay in the hospital overnight (inpatient), while others go home the same day (outpatient). The surgeon identifies the holes or tears either through the operating microscope or a focusing headlight (indirect ophthalmoscope). The hole or tear is then sealed, either with diathermy (an electric current which heats tissue), a cryoprobe (freezing), or a laser. This results in scar tissue later forming around the retinal tear to keep it permanently sealed, so that fluid no longer can pass through and behind the retina. A scleral buckle, which is made of silicone, plastic, or sponge, is then sewn to the outer wall of the eye (the sclera). The buckle is like a tight cinch or belt around the eye. This application compresses the eye so that the hole or tear in the retina is pushed against the outer scleral wall of the eye, which has been indented by the buckle. The buckle may be left in place permanently. It usually is not visible because the buckle is located half way around the back of the eye (posteriorly) and is covered by the conjunctiva (the clear outer covering of the eye), which is carefully sewn (sutured) over it. Compressing the eye with the buckle also reduces any possible later pulling (traction) by the vitreous on the retina.

A small slit in the sclera allows the surgeon to drain some of the fluid that has passed through and behind the retina. Removal of this fluid allows the retina to flatten in place against the back wall of the eye. A gas or air bubble may be placed into the vitreous cavity to help keep the hole or tear in proper position against the scleral buckle until the scarring has taken place. This procedure may require special positioning of the patient’s head (such as looking down) so that the bubble can rise and better seal the break in the retina. The patient may have to walk, eat, and sleep with the head facing down for two to four weeks to achieve the desired result.

Good luck and best wishes for an improved result.